Anti-slip plywood PREMIUM
Exterior birch plywood overlaid with a phenol film on both the sides. The wear side has a rough wire mesh pattern (W); the reverse side normally is smooth (F), although it can have wire mesh pattern, too (grade W/W). Anti-slip plywood rough wire mesh overlay withstands hard wear and it can be used for many different floor-panelling purposes.

THICKNESS

4, 6,5; 9; 12; 15; 18; 21; 24; 27; 30; 35; 40, 50, 60 mm

TOLERANCE

Size and right angle tolerance meets the standard EN 315 requirements.

SIZES

  • 1250 x 2500 / 2700 / 3000 / 3300 mm
  • 1500 x 2500 / 2700 / 3000 / 3300 mm
  • 1550 x 2500 / 2700 / 3000 / 3300 mm
Cut to size panels and machining available in accordance with the customers' requirements.

FILM COLOUR

SNormally dark brown (120g/m2). Other standard colours are light brown (120g/m²), dark brown (220g/m²), green (120g/m²), black (120g/m²). Grey (174 g/m²) and red (220 g/m²) colours on special order.

APPLICATIONS

Vehicle floors, pedestrian bridges, storage and factory floors, storage shelves, loading platforms, ship decks, pier surfaces. In general - applications where high wear resistance and/or good anti-slip properties are required.

ADVANTAGE

The wire mesh surface has high wear resistance and anti-slip properties, surface is weather and waterproof, resists to commonly used chemicals. Environmentally friendly.

GLUING CLASSES

Plywood is glued with waterproof phenol formaldehyde resin adhesive. Bonding is resistant to weather and boiling water. It meets requirements of the following standards:
  • EN 314 / 3rd class;
  • BS 1203 / H4 (previously WBP);
  • DIN 68705 Part 3 / type BFU 100;

FORMALDEHYDE EMISSION

In accordance with the standard EN 13986 formaldehyde emission meets the Class E1 requirements. Test method EN 717 Part 2.

OVERLAYING

The panels are overlaid with a phenol film and have a wire mesh pattern imprinted during hot pressing process. The reverse side overlaid with a similar phenol film, and normally the reverse side is smooth. The unit weight of Anti-slip plywood film is 120g/m2 or 220g/m2. On special request, panels can be overlaid with multi-layer phenol film and both the sides can have a wire mesh pattern.

OVERLAYING CHARACTERISTICS

The overlaying surface is highly resistant to abrasive wear and it does not crack. It is also resistant to weather and moisture as well as commonly used chemicals. The wire mesh patterned surface provides high anti-slip properties. Anti-slip panels can be machined by using normal woodworking equipment. During machining extra hard cutting tools are recommended. Abrasion resistance according to the Taber test (EN 438-2): depends on applied film, surface texture*, conditions of product storage and application, thickness of film.
  • 120 g/m² - 400 revolutions
  • 220 g/m² - 750 revolutions
  • 440 g/m² - 1900 revolutions
Small mesh resistance to wear parameters mesh ones. It is possible to obtain overlaid plywood above 10 000 revolutions. Company’s specialists will assist you to choose the most appropriate product.

EDGES SEALING

Edges of the panels are matched with the face against absorption of moisture by using acrylic paint. Other colours are available and the edges may be unsealed at customers' request.

PLYWOOD PHOTOS

ANTI-SLIP PLYWOOD PREMIUM